U-Mount repositinal stamp mounting foam.
1. Cut out your chosen rubber stamp design with a sharp pair of scissors. Do not trim too close to the design as the image will not print properly.
2. Cut a piece of u-mount slightly larger then the die, peel paper away from the sticky side of the cushion and press die onto it.
3. Cut the stamp design out with a sharp pair of scissors, remembering to leave a border of a few millimetres. It is essential that you do not undercut the die. The cut should slope away from the die, so that the die receives even pressure when stamped.
4. Peel paper from the u-mount side of the cushion and press the design firmly onto your choice of acrylic block.
5. Ink up the image and stamp your design as normal. When finished, clean your stamp, taking care not to get water on the u-mount.
