A4 size sheet of Kling-On, similar to EZ-Mount but made here in the UK
1. Trim the die using a sharp pair of scissors (some of the stamps are already trimmed) leaving a very small border. It is important not to undercut the stamp or the design will not print properly.
2. Cut a piece of 
slightly larger than the die and peel away the paper from the sticky side of the cushion, and press the die on to it.
3. Use a sharp pair of scissors and cut the stamp design out, leaving a border of a few millimetres. NB it is important NOT to undercut the die. The cut should slope away from the design, not underneath it Practise on a corner of the sheet first . It may be better to cut on the left side of the die.
4. Press the cushion side firmly on a clear acrylic block. The Kling-On will adhere time and time again to the acrylic block making it easy to use different designs on the same block.
5. Stamp your design. Clean your stamp and store on a clear plastic sheet or holder.
